6
EN
fan heater TFC 220 E
Assembly
Feet assembly
1. Place the device on a table or on the packaging board with
the glass surface pointing down.
2. Fasten both feet (3) with two screws each.
3. Check the feet (3) for tight fit.
4. Set the device up in an upright and stable position.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Set the device up in an upright and stable position.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Do not position the device directly below a wall socket.
•
Make sure that the device cannot come into contact with
moisture or water.
Prior to initial start-up, insert the batteries in the remote control.
Connecting the power cable
•
Insert the mains plug into a properly secured mains
socket.
•
Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
