EN
8
Operating manual – cordless tacker PTNS 10-3,6V
Information on noise and vibration:
•
The vibration level specified in these instructions was
determined by means of a measuring method standardized
in EN 60745 and can be used for a device comparison. The
specified vibration emission value may also be used for a
preliminary assessment of the exposure.
Caution
Vibration emissions can cause a health hazard if the
device is used for an extended period of time or if it is
not properly handled and maintained.
•
The vibration level will change depending on the
application of the power tool and may in some cases differ
from the value specified in these instructions. The vibration
load may be underestimated if the power tool is used
regularly in such a way. For a precise estimation of the
vibration load during a certain work period, it is also
important to consider the periods during which the device
is switched off, or is running but not actually employed.
This can reduce the vibration load over the entire work
period significantly.
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down.
The supplied Li-ion batteries are subjects to the requirements of
dangerous goods legislation.
Observe the following when transporting or shipping Li-ion
batteries:
•
The user may transport the batteries by road without any
additional requirements.
•
If transport is carried out by third parties (e.g. air transport
or forwarding company), special requirements as to
packaging and labelling must be observed. This includes
consulting a dangerous goods specialist when preparing
the package.
– Only ship batteries if their housing is undamaged.
– Please also observe any other national regulations.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down.
•
Clean the device as described in the Maintenance chapter.
•
Do not store Li-ion batteries which are completely
discharged. Storing discharged batteries can lead to a
deep discharge and thus damage the battery.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
ambient temperature below 40 °C
•
protected from dust and direct sunlight
