EN
19
cordless angle grinder PAGS 21-115
Switching the device on and off
Wear your personal protective equipment when working with
the device.
1. Check whether the mounted cutting disc is suitable for the
intended application.
2. Check whether the workpiece is secured and the worktop
prepared correspondingly.
3. Slide back the start lock (18) at the on/off switch (5).
4. Press the on/off switch (5) and hold it during operation.
18
5
5. Carry out a test run of approx. 1 minute without load prior
to every disc change and every start-up in order to check
the cutting disc for correct fit.
6. After switch-on, wait until the device has reached its
maximum speed. Only then start working.
7. To switch the device off, let go of the on/off switch (5).
Caution
The disc keeps running after the device has been
switched off.
Risk of injury.
5
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
If required, allow the device to cool down.
•
Remove the battery from the device (see Start-up chapter).
•
Remove the tool from the device (see Start-up chapter).
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
