16
EN
cordless angle grinder PAGS 21-115
Tool change
The cutting disc for metal is preassembled.
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket and the battery from the device!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning of hot surface
The insertion tool might still be hot after the
application. Burn hazard when touching the insertion
tool.
Do not touch the insertion tool bare-handed!
Wear protective gloves!
To change the cutting disc, please proceed as follows:
ü
The spindle is at a standstill and the cutting disc is no
longer rotating.
1. Remove the battery from the device.
2. Remove the face spanner (11) from the additional
handle (14).
11
14
3. Press the spindle lock (1) to block the gears.
4. Slowly turn the clamping nut (16) to the locking point until
the lock is fixed. Press and hold the spindle lock (1).
5. Use the face spanner (11) to unscrew the clamping
nut (16) counter-clockwise. Then let go of the spindle
lock (1).
1
11
16
6. Remove the used cutting disc (17). Make sure that the
mounting flange (15) is firmly locked in place in the
designated recesses.
15
17
