12
EN
air cooler PAE 45
Air cooling
The
air cooling
mode can be switched on in addition during all
other operating modes.
During
air cooling
mode, the pump is switched on and the water
is distributed over the evaporation filter to cool the circulating
air with water. In air cooling mode the air is humidified at the
same time.
Please proceed as follows to activate
air cooling
:
ü
The water tank (
7
) must be filled up with water at least to
the minimum filling level.
1. Press the
air cooling
button (
19
).
ð
The
air cooling
LED (
24
) is illuminated.
ð
The pump starts.
2. Press the
speed
button (
16
) to set the desired fan speed.
ð
The set fan speed and the symbol are indicated on
the segment display (
23
).
3. Press the
cooling
button (
19
) again to switch air cooling
off.
ð
The
air cooling
LED (
24
) goes out.
ð
The device continues to run in the previously selected
operating mode with the pump being switched off.
Note
When
Air cooling
mode is activated, the air and
evaporation filter must not be removed, otherwise the
water from the filter will drip down into the device.
Note
The air cooling LED (
24
) flashes when the water tank is
empty. Fill the water tank as described in Filling the
water tank.
Ventilation
In
ventilation
mode, you can select all 5 fan speeds manually.
Please proceed as follows to activate
ventilation
:
1. Press the
speed
button (
16
) until the desired fan stage is
indicated on the segment display.
ð
The set fan speed and the symbol are indicated on
the segment display (
23
).
Air freshening
In
air freshening
mode, the fan speed increases and decreases
alternately to generate a pleasant, natural air stream.
Please proceed as follows to activate
air freshening
:
1. Press the
mode
button (
18
) until the
air
freshening
LED (
22
) is illuminated.
ð
The fan speed levels change automatically.
ð
The current fan speed and the symbol are indicated
on the segment display (
23
).
Night mode
In night mode, the device operates using a preset programme
with different fan speeds to generate an air stream that is
adapted to human sleeping habits.
Night mode can be activated in combination with the 5 fan
speeds and
air cooling
.
1. Press the
mode
button (
18
) until the
night mode
LED (
21
)
is illuminated.
2. Press the
speed
button (
16
) to set the desired fan speed.
ð
The set fan speed and the symbol are indicated on
the segment display (
23
).
ð
The air current automatically regulates at all fan speeds.
After 30 minutes, the device always switches over to a
lower stage until fan stage 1 is reached.
Info
If you activate
air cooling
, an alarm signal will be
emitted when the water tank is empty, even in night
mode.
Setting the timer
The function can be set in addition in all operating modes.
The number of hours can be set in hourly increments (1 h
to 9 h).
Automatic switch-off
ü
The device is switched on.
1. Press the
timer
button (
17
) until the desired number of
hours is shown on the segment display (
23
).
ð
The segment display (
23
) indicates the set number of
hours and the
h
symbol.
ð
The timer programming is activated.
ð
The timer setting equals the desired number of hours.
ð
The device switches off automatically after the set
number of hours has elapsed.
