EN
3
radiant heater IR 2550 S / IR 2570 S
Warning
Do not use the device in small rooms if persons are
present who cannot leave the room independently and
who are not under constant supervision.
•
Do not use the device in potentially explosive rooms or
areas and do not install it there.
•
Do not use the device in aggressive atmosphere.
•
Let the device dry out after a wet clean. Do not operate it
when wet.
•
Do not use the device with wet or damp hands.
•
Do not expose the device to directly squirting water.
•
Never insert any objects or limbs into the device and never
use it as source of ignition.
•
Do not cover or transport the device during operation.
•
This appliance is not a toy! Keep away from children and
animals. Do not leave the device unattended during
operation.
•
Check accessories and connection parts for possible
damage prior to every use of the device. Do not use any
defective devices or device parts.
•
Ensure that all electric cables outside of the device are
protected from damage (e.g. caused by animals). Never
use the device if electric cables or the power connection
are damaged!
•
The electrical connection must correspond to the
specifications in chapter Technical data.
•
Insert the mains plug into a properly secured mains
socket.
•
Observe the device's power input, cable length and
intended use when selecting extensions to the power
cable. Completely unroll extension cables. Avoid electrical
overload.
•
Before carrying out maintenance, care or repair work on
the device, remove the mains plug from the mains socket.
Hold onto the mains plug while doing so.
•
Switch the device off and disconnect the power cable from
the mains socket when the device is not in use.
•
Do not under any circumstances use the device if you
detect damages on the mains plug or power cable.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Defective power cables pose a serious health risk!
•
During the installation of the device observe the minimum
distances from walls and other objects as well as the
storage and operating conditions specified in the Technical
data chapter.
•
Do not use the device in immediate proximity to curtains,
beds or sofas.
•
Do not transport the device during operation.
•
Allow the device to cool down before transport and / or
maintenance work.
•
Do not use this device near bathtubs, shower trays,
swimming pools or other water containers. Risk of electric
shock!
•
The device must not be installed directly beneath a wall
socket.
•
The device must be set up in a way that the switches and
controllers cannot be touched by a person in a bathtub or
shower.
•
The device must not be used with a programming switch,
timer, separate remote control system or similar
equipment that switches the device on automatically, as
this could cause a fire hazard if the heater is covered or
positioned incorrectly.
Intended use
Use the device for heating surfaces in roofed outdoor areas
protected from weather effects.
Intended use comprises:
•
heating surfaces
– in storage facilities,
– in construction areas,
– in containers,
– in the catering trade,
– at trade fairs and events,
– in roofed outdoor areas (e.g. covered terraces).
Improper use
The device is not intended for industrial use.
•
Do not place any objects, e.g. clothing, on the device.
•
Do not use the device for heating in vehicles.
•
Do not use this device in the vicinity of fuel, solvents,
varnishes or other easily inflammable vapours or in rooms
where these substances are stored.
•
The device may not be used as a heating device for
babies / children or animals.
•
The device may not be installed inside a shower or directly
above a bathtub.
•
The device must not be used near swimming pools.
•
Do not use this device in the immediate vicinity of sinks,
bathtubs or other water containers.
Never immerse the device in water.
•
The device may not be exposed to moisture or weather
effects (rain, sunlight).
•
The device must not be mounted to the ceiling.
•
Any operation other than as described in this manual is
prohibited. Non-observance renders all claims for liability
and guarantee null and void.
