EN
13
oil heater IDS 30 F
Start-up
•
Check the scope of delivery of your device for
completeness. If an accessory part is missing, please
contact the Trotec customer service or the specialist dealer
where you purchased the device.
•
Check the device and its connection parts for potential
damage.
•
Observe the conditions described in the chapter
Positioning.
•
Install the exhaust system of the device in a technically
correct manner. You can also connect the device to a flue
or an outer wall as illustrated in chapter Assembly.
•
Connect the device to an external tank or jerrycan as
described in the chapter Establishing the oil supply.
•
Check the device for its proper condition prior to start-up
and at regular intervals during application.
•
Check whether the characteristics of the power grid
conform to those on the nameplate.
•
Each time before you plug the mains plug into the mains
socket and switch on the device, make sure that the fan is
moving freely.
•
Connect the mains cable to a properly secured
socket (230 V / 50 Hz / 10 A). On construction sites, there
must be a residual current device (RCD) upstream of the
socket in accordance with national regulations (in
Germany: VDE 0100/0105).
The device is now ready for operation.
Operation
The device may only be used by accordingly instructed persons.
Operating elements
Warning
Fire hazard if device is covered or due to incorrect
positioning of the device!
There is a risk of fire if the heating device is covered or
incorrectly positioned.
Never cover the device during operation and position it
with sufficient distance to walls and objects (according
to the chapter Technical annex).
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Do not touch the mains plug with wet or damp hands.
Hold onto the mains plug while pulling the power cable
out of the mains socket.
22
23
24
25
21
No.
Designation
21
Selector switch:
•
l
=
ON
(activate manual operation)
•
0
= switch the device off
•
l
=
ON
(activate automatic operation)
22
Thermostat socket
23
Lamp
24
Power cable
25
Reset button
The device has two operating modes:
•
Manual operation
•
Automatic operation with external thermostat (optional)
