12
EN
oil heater IDS 20 D / IDS 30 D
The flame goes out during combustion:
•
Make sure the air supply is unobstructed. If required, clean
the air intake opening.
•
Check the filling level of the tank. Refill with fuel if the tank
is empty (see chapter Operation).
•
Check the fuel filter in the fuel pump for dirt. If it is dirty,
please contact the customer service.
•
Check the fuel for contaminations and replace it if
required.
•
Power failure: In the event of a power failure the ignition is
extinguished, the device switches off immediately. After a
power failure the device will not restart automatically, it
has to be started via the on/off switch.
There is a fuel leak:
•
Check whether too much fuel was filled in. Drain the fuel if
necessary, see chapter Draining the tank.
•
Check the drain screw for tight fit and retighten it if
necessary.
•
Check the sealing at the drain screw and replace it if
damaged.
•
Check the fuel pump for leaks. If there are doubts about
the proper condition of the fuel pump, please contact the
customer service.
The device emits smoke or dust:
•
Check the mains voltage.
•
Check the fuel for contaminations and replace it if
required.
•
Check the tank for contaminations and drain it if required
(see chapter Maintenance). Refill with clean fuel.
The flame emerges from the air outlet:
•
Check the mains voltage.
•
Check the fuel for contaminations and replace it if
required.
•
Check the tank for contaminations and drain it if required
(see chapter Maintenance). Refill with clean fuel.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorized specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down completely.
Warning of electrical voltage
Tasks which require the housing to be opened
must only be carried out by authorised specialist
companies or by Trotec.
Cleaning the housing
Clean the housing with a soft, damp and lint-free cloth. Ensure
that no moisture enters the housing. Protect electrical
components from moisture. Do not use any aggressive cleaning
agents such as cleaning sprays, solvents, alcohol-based or
abrasive cleaners to dampen the cloth.
Wipe the housing dry after cleaning.
Filling the tank
The fuel tank cap is located at the side of the
IDS 20 D / IDS 30
D
. The images in the description below show the IDS 30 D by
way of example.
ü
Before attempting to fill the tank, wait until the device has
cooled down completely.
ü
Only use fuel suitable for the device (see technical data).
1. Position the device on firm, level and incombustible
ground.
2. Unscrew the fuel tank cap (7).
7
