Operating Manual – Electronic Humidifier
B -
6
EN
13. Radio-sensor-system
(Radio frequency 435 MHz)
Starting up
Carefully loosen the underneath of the housing, e .g .
with a screwdriver . Replace the batteries (MN 1500
LR6, 1,5 V AA) .
m
Make sure the poles (+/–) are inserted cor-
rectly.
Press the small black test knob
1
to check the trans-
mission function (the green test diode
2
should light
up) . Please attach it to a dry, well ventilated place
such as a ceiling or a wall and make quite sure it is
not exposed to any direct sunlight . (The calibration is
factoryadjusted to 2%)
14. Coding the radio sensor system
Coding the sensor
These appliances are coded in the factory, but if two
or more are used in direct proximity to one another
(i .e . less than 50 metres apart) a different coding may
be necessary .
a) Device circuit board B 500
b) Radio sensor circuit board
For each slide control there are only two positions:
„ON”= up and „0FF” = down, which give 16 possible
combinations . Please note: each appliance and its ra-
dio sensor (a + b) must have the same coding .
You have the option here of controlling a number of ap-
pliances in one room from one sensor, with all of them