EN
7
cordless high-pressure cleaner PPWS 10-20V
Technical data
Parameter
Value
Model
PPWS 10-20V
Nominal voltage
20 V
Max. pressure
22 bar
Flow rate
120 l/h
Inlet water pressure
0.5 Mpa
Max. water temperature
65 °C
Suction height
- optimum
- max.
1.5 m
4.0 m
Spraying range
7 m
Weight
1 kg
Battery
Multiflex 20 – 2.0 DC
Type
Li-ion
Nominal voltage
20 V
Nominal capacity
2.0 Ah
Rechargeable cells
5 cells
Capacity
40 Wh
Quick charger
Multiflex 20 – 2.0 AC
Input
Nominal voltage
230 – 240 V / 50 Hz
Power input
65 W
Output
Nominal voltage
21.5 V
Charging current
2.4 A
Fusing
3.15 A (slow-blowing)
Charging time
1 h
Cable length
1.5 m
Protection class
II (double insulation) /
Vibration information according to EN 60335-2-54
Total vibration emission
value a
h
Uncertainty K
2.5 m/s²
1.5 m/s²
Sound values according to EN 60335-2-54
Sound pressure level L
PA
83.7 dB(A)
Sound power L
WA
89.0 dB(A)
Uncertainty K
3 dB
Wear hearing protection.
Excessive noise can lead to hearing loss.
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down.
•
Remove the battery from the device.
The supplied Li-ion batteries are subjects to the requirements of
dangerous goods legislation.
Observe the following when transporting or shipping Li-ion
batteries:
•
The user may transport the batteries by road without any
additional requirements.
•
If transport is carried out by third parties (e.g. air transport
or forwarding company), special requirements as to
packaging and labelling must be observed. This includes
consulting a dangerous goods specialist when preparing
the package.
– Only ship batteries if their housing is undamaged.
– Mask open terminals with tape and pack the battery in
a way that it cannot move inside the packaging.
– Please also observe any other national regulations.
Storage
Before
storing the device, observe the following:
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down.
•
Remove the battery from the device.
•
Drain the water completely from the device. Disconnect
the connections to the water supply. Then switch the
device on for some seconds until the water ceases to exit
the spray lance. Switch the device off.
•
Store the spray lance in a standing position, the connection
side pointing downwards.
•
Completely empty the hose with filter.
•
If there are any residues of water on the device and
accessories, damage can be cause by frost.
•
Store the device and its accessories in a frost-free
environment.
•
Clean the device as described in the Maintenance chapter.
