6
EN
radiant heater IR 2200
Assembly and start-up
Scope of delivery
•
1 x Device
•
1 x Wall holder
•
2 x Wire rope
•
3 x Screw
•
4 x Wedge bolt
•
1 x Allen wrench
•
1 x Wrench
•
1 x Remote control
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning of electrical voltage
Risk of injury due to incorrect assembly!
Local or national regulations may apply for installation.
We recommend to have the installation carried out by a
qualified electrician.
The device is suited for wall and ceiling mounting. Observe the
following requirements for the installation:
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Mounting the wall holder
ü
Use tools suitable for the intended task.
1. Fasten the device to the wall holder by tightening the wall
holder to the device by means of the three screws (as
indicated).
ð
Check whether the wall holder is firmly attached to the
device.
2. The position of the holder can be freely adjusted.
Mounting the ceiling holder
ü
Use tools suitable for the intended task.
1. Attach the device with the two wire ropes by tightening the
wire ropes in the holes provided (
4
) on the device (as
indicated).
ð
Check whether the wire ropes are firmly attached to the
device.
4
