Load and unload filaments
:
After waiting for temperature up to 180
℃
, consumables through the
run out detection, extruder and feed pipe until the nozzle has
consumable extrusion, as shown in the figure below:
Straighten
Filament
Print test
:
Click
→
“
TEST FILE
”
→
,
Start printing
If the filaments cannot stick to the first layer when printing, the
nozzle will be on the high side. The Z offset value can be
appropriately increased when setting the Z offset value, or a lower
first layer height can be set when setting the slice.If the feeding of
nozzle filament is very small, the nozzle is too low. The z-offset
value can be appropriately reduced when setting Z offset or the
first layer height can be set higher when setting slice.
10
Filament run
out detection
Extrusion
Feed pipe
Click
23/0
23/199
Summary of Contents for XY-2 PRO
Page 1: ......
Page 10: ...7 Operation Print 8 ...
Page 14: ...2 How to use slice software Type setting follow the steps below to complete the setting 12 ...
Page 19: ......