TRONXY X6-2E, Instructions Manual

Page: 18 / 25

Adjusting nut
3.6.1Click the emergency icon, the machine stops in the current state,
and the motor unlocks.When adjusting the gap between the printing
platform and the nozzle, use emergency stop to let the extruder slide
freely.Gap size, with a piece of A4 paper between the nozzle and the
platform sliding resistance, but do not tear the paper is appropriate.The
platform should be positioned near the support point of the
platform,The platform should be positioned near the support point of
the platform, but avoid screw holes. Adjust each support point.
3.6.2Will print platform of the first four adjusting nut is tightened, the
spring pressure in the shortest possible location, click on the icon ,
extrusion head down, run into the Z axis stop switch, adjust the position
of the switch, to squeeze head nozzle and the platform about 2-3 mm
apart, then loosen the adjusting nut, fine-tuning platform for extrusion
head nozzle and the mobile platform about 2-3 mm apart, Distance
from the nozzle to an A4 sheet of paper thickness.
3.7Click the Z offset icon to enter the Z axis position adjustment.The
function of automatic leveling is effective.Select the fine tuning 0.1mm
icon, click the icon Z axis to move up, and click the Z axis to
move down.djust the nozzle and platform to A4 paper thickness. Click
the icon set Z to zero and save the setting.
This function is automatically leveling Z axis compensation, with leveling
function used, leveling simple.This function is not available on this
machine.
The Z axis switch
3.5Click the fan icon to enter the fan setting, and turn the fan value 0
OFF, 100 ON, light ON, and light OFF.