TRONXY X6-2E, Instructions Manual

Page: 11 / 25

12 p female terminal
Assembly parts:
You can select 110V voltage.
5.Remove the power cord and plug into the 3P port of the host power supply.
printer(included wiring) 1pcs
4.According to the local voltage, select the power supply voltage of the host. As
shown, the position shift is 220V, and the toggle switch is to the right.
The rest is plugged into e2-motor.
Step 4: wiring
Power supply
voltage
selection
Make sure the debugging is good.
1. Insert the male terminal of the shelf 12P wire into the female terminal of the
left rear side of the base.
2. 2Motor 6P terminals protruding from the left back side of base, short plug in
z1-motor, long plug in e1-motor.
3. 3 Motor 6P terminals protruding from the right rear side of the base are
inserted into z2-motor for short while x-motor for long.
Power line 1pcs
X-MOTOR
Z1-MOTOR
Z2-MOTOR
E1-MOTOR
E2-MOTOR