TRONITEK DENAS Reflexo, Operation Manual, Page: 38 / 64

38
3. COURSE OF TREATMENT
20 - 30 minutes before the session for hygienic purpose it
is recommended to treat the work surface of the electrode
with a soft brush or lint-free tissue, damped with a disinfec-
tion solution (e.g. 3% solution of hydrogen peroxide).
Attention!
If the skin is too dry it is allowed to
damp slightly the skin surface with physiological
solution 5 - 10 before the application of the exter-
nal electrode to ensure tight contact and intensify
treatment impact.
3.1.
Place the electrode on a flat dry surface (e.g. on the
floor before the armchair).
3.2. Connect the electrode to the socket of the dynamic
electrostimulation device (if necessary use a special adapt-
er).
3.3.
Put bare feet on the electrode so that the smooth divid-
ing line appears to be approximately in the middle of the
foot (fig. 4). Moving the feet on the surface of the electrode,
find a position where the contact with the electrode is the
tightest.
Attention!
The correct position of feet on the elec-
trode is shown on figure 4.
Attention!
Do not move the electrode during the
stimulation!
It is required to clean the contact part of the device before
and after its use. Disinfection should be made with a stand-
ard disinfection solution (e.g. 3% solution of hydrogen per-
oxide).