Tronair 08-2030-0000, Operation & Service Manual

Page: 6 / 15

Model: 08-2030-0000
Engine Work Stand
05/2007 | Rev. 03 Page | 3
4.0 OPERATION
1. Engine stand requires use of specific engine adapter kit (not included with engine stand).
2. Attach appropriate sling (not included with engine stand) to engine and remove from aircraft according to the
m
anufacturer’s instructions.
3. Attach the front and rear mounting adapters to the engine. (See Figure 2 )
4. Lock caster brakes on stand.
5. Align the engine with the main post assembly on the engine stand. Be sure that the front of the engine is positioned
towards the main post assembly.
6. Carefully move engine into stand and make the final position adjustment of the main post assembly relative to the fixed
rear post location.
7. Attach front and rear engine mount adapters to the engine stand attach points. Make all final adjustments to allow for
good engine positioning on engine stand.
8. Tighten down main post assembly lock out screws by alternating until both are tight. (See Figure 3)
9. Remove hoist from engine and work area.
10. Reverse steps 1 through 9 to remove engine.
FIGURE 2
FIGURE 3