Tronair 08-2030-0000, Operation & Service Manual

Page: 5 / 15

Model: 08-2030-0000
Engine Work Stand
05/2007 | Rev. 03 Page | 2
2.0 ASSEMBLY INSTRUCTIONS
This product should be assembled and/or repaired using good workmanship practices and proper tools.
2.1
ASSEMBLY STEPS
The main post assembly and rear mounting support are
reversible for mounting left or right hand engines. The engine
stand is designed to handle various length engines by way of
a roller mounted main post assembly that allows for
adjustability of 15-5/8 inches to 55 inches from the rear engine
attach point. The rear attach post height is fully adjustable
through 22" in one-half inch increments.
2.1.1
Install Main Post Assembly
1. Remove rail pins.
2. Orientate main post assembly for left or right hand
engine.
3. Rotate main post assembly to allow the lead rollers to
lead into the support rails in the base and tilt main post
assembly until the main post assembly is in the vertical
position. (See
Figure 1 ).
4. Roll main post assembly forward until located in
approximate position for engine to be mounted.
5. Re-install rail pins.
2.1.2
Install Rear Engine Support Post
1. Orientate rear engine support post for left on right hand engine
2. Locate rear support to approximate engine, attach height and pin into place with post pin.
2.2
PRE-USE CHECKS

Refer to the parts list and illustration attached to identify and assure that all parts are present.

Generally check the entire unit to assure the tightness of all nuts and bolts, etc.
3.0 TRAINING
3.1 TRAINING REQUIREMENTS
The employer of the operator is responsible for providing a training program sufficient for the safe operation of the unit.
3.2
TRAINING PROGRAM
The employer provided operator training program should cover safety procedures concerning use of the unit in and around the
intended aircraft at the intended aircraft servicing location.
3.3
OPERATOR TRAINING
The operator training should provide the required training for safe operation of the unit.
NOTE: Maintenance and Trouble Shooting are to be performed by a skilled and trained technician.
FIGURE 1