USER MANUAL TST40G, V15.01
page
|
19
Technical changes, misprints and errors are reserved.
Step 1: Raise the lift
a. Make sure you have read and understood the user manual before
operation.
b. Position the vehicle midways between the two posts.
c. Adjust the lifting arms until they reach the vehicle manufacturer´s
recommended lifting points of the vehicle to be lifted and make sure that
the center-of gravity of the vehicle is in the center of the lifting arms.
d. Connect the power supply as per the requirements on the nameplate
attached, and switch on.
e. Press and hold
the “UP” button on the control box until the pads of the
lifting arms reach the vehicle manufacturer´s recommended lifting points
and check the correct position of the lifting pads.
f. Keep on raising the vehicle to let it have a bit of clearance from the ground
and check again the stability of the vehicle and the correct position of the
lifting arms.
g. Raise the vehicle to the desired height and check if its position is safe and
stable.
Step 2: Lock the lift
a.
Press and hold the “LOCK” button, to lock the safety latch.
b. Now you can start the maintenance or repair work underneath the vehicle.
Step 3: Lower the lift
a. Pre
ss and hold the “DOWN” button in the control box to start the lowering
cycle.
b. The lift will first raise a little, in order to unlock the safety latch. Then the lift
will begin to lower.
c. After the lift has reached its lowest position pull out the lifting arms from
underneath the vehicle and clear up all obstacles.
d. Move the vehicle out of the lifting area.
