10200-7
4. ASSEMBLY STEPS
Recheck
All bolts and nuts are
tightened securely
before using the machine
• Two people are required to complete the assembly.
• Follow the steps below to avoid injury.
STEP 1 – UPRIGHT ASSEMBLY
• Raise the Left and Right Uprights into the vertical
position and secure them into place with one Bolt (72),
one Arc Washer (65), one Nylon Nut (71) and one
Bolt (57).
• Tighten the Pop-Pin Head (10) on the Right Upright.
STEP 2: HANDRAIL ASSEMBLY
• Thread the Control Wires into the hole of the Lower
Computer Shelf (2), then pull them out of the hole of
the Upper Computer.
• Connect the Control Wires of the Upright to the
Control wires in the Handrail.
• Insert the Handrails into the Uprights and secure with
two Allen Bolts (78) on each side.
STEP 3 – COMPUTER AND BOTTLE
HOLDER ASSEMBLY
• Place the Bottle Holder (84) on the top of the
Computer Handrail and secure it with two Screws (101).
• Hold the Computer Consol (1) above the top of the Water
Bottle Holder and connect all the Control Wires. Make sure
the connected wires are pushed back into the Handrail
Tube (2) once connected.
• Attach the Computer Consol (1) onto the Handrail (2),
securing with four Screws (7).
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.
Summary of Contents for WALKER 110
Page 20: ...10200 20 14 EXPLODED DRAWING...