Trojan TR 1500, User Manual

Page: 18 / 32

18
TR 1500 - T
TROUBLE SHOOTING
ERROR CODE MAIN REASON SOLUTION TO ERROR
E01 This error indicates a possible
message failure between computer
and bottom control board. 1. Check that the computer and bottom
control board wires are connected
correctly.
2. Change the entire control board.
E02 This error indicates a protection
against exploding. 1. If there is bad connection with an open
circuit in the motor, please change to a
new motor or check the connection.
2. If the power cable has a puncture. Please
change to a new Power cable or control
board.
E03 This error indicates a possible no
sensor signal. 1. Check that the speed sensor wire
connection is correct. If not, then
reconnect the wire
2. Check if the speed sensor is damaged. If it
is, then change to a new speed sensor.
E04 This error indicates a possible incline
motor study failure. 1. Check if the incline motor wires have been
connected correctly. If not, re-connect
them.
2. Check if wire on the incline motor is
damaged. Change wire if required.
3. After checking all the above, press the
study key on the incline motor to reset.
E05 This error indicates a possible
current overload. 1. If current overload has been detected
or the motor is stuck this will cause an
excessive current and the machine will
start self-protecting its system. Adjust
the machine and restart.
2. Check if the motor has a noise coming
from the it or if the motor / bottom
control board has burnt out. If it has burnt
out, then change to a new motor and/or
bottom control board. Use correct voltage
moving forward.
E08 This error indicates a possible driver
problem. 1. Check if the 8pin 24C02 integrated circuit
on the bottom control board is connected
correctly. If not, then reconnect it.
2. You may need to change the bottom
control board.