Trojan SOLITUDE 400, Care Instructions And Assembly Manual

Page: 23 / 28

1562-23
13. FREQUENTLY ASKED QUESTIONS
Q1. My treadmill will not start up?
- Is the power cord connected to the power outlet, and turned on?
- Is your treadmill power button turned on?
- Do you have power supply to your home?
- Is your safety key attached to the consol?
Q2. My treadmill has stopped working and is showing an E1 error
- This occurs when the motor is under strain
- Restart the treadmill and check that the running belt is well lubricated so the motor is not overloaded.
- If the error continues, please contact the Trojan service centre on 0861 876526 (0861 TROJAN)
Q3. My treadmill is showing an E6/E7 error
- This occurs when there is an abnormality in the incline function
- Restart the treadmill and see if the error is rectified and the readmill can be operated normally
- If the error continues, please contact the Trojan service centre on 0861 876526 (0861 TROJAN)
Q4. How important is it to do maintenance on the treadmill?
Very important, most motor failures are directly attributed to the additional stress placed on it by virtue of:
a) Not lubricating the running deck,
b) Incorrect mat alignment causing drag and
c) Incorrect mat tension causing slipping on the drive rollers.
Q5. Should I bring back my treadmill to zero incline once I have finished my workout?
- Yes.
Q6. How often should I lubricate my running deck?
- Refer to recommendation on page 9
Q7. Should I always unplug my unit from my wall socket when not in use?
- Yes.
Q8. My belt is making a rubbing sound. How do I rectify this problem?
- Ensure the deck is well lubricated and that it is well aligned.
Q9. My display panel is very faint?
- Ensure the unit is not in direct sunlight. Remove the plastic film on monitor. If the problem persists,
please contact your local Trojan Service Centre on 0861 876526 (0861 TROJAN)
Q10. Is it wise to extend my power cable?
No, as any modifications to the unit could affect it and your warranty.
Q11. Can I stop halfway through my workout and then resume from where I stopped?
Yes, with the new Platinum Range, pressing stop during a program will pause the program. To resume
again, press start.