苏
州
特
鲁
利
电
子
材
料
有
限
公
司
Suzhou Trojan Industry Material Co.
，
Ltd.
地地址：
江苏省苏州市工业园区新泽路 53 号 A 幢
电话：
0512-67580617
传真：
0512-67508229
Start / stop buttons:
Start or stops the head in the manual mode. Note the Start/Stop button on the base
polisher controls the Automatic polishing operation.
Auto/ manual:
Manual mode operates the head independent of the polisher.
Auto mode operates head in conjunction with the polisher.
Pistons Up/Down:
UP/DOWN controls the pistons in the manual mode.
Motor speed:
UP/DOWN arrows for increasing or decreasing the speed.
Head speed indicator:
Displays the motor speed (0-200 rpm).
Pressure adjustment:
Controls the pressure applied to the pistons.
3.2 Base Polisher Control Panel
Wheel direction:
Clockwise rotation or counter clockwise rotation.
Run / stop buttons:
Start/stop the polishing wheel in both manual and auto mode.
Water switch:
Activates the water solenoid for the rinse bowl and rinse spout.
Preset speeds:
Allows for faster speed control, SPL - low speed, SPM - medium speed, SPH - high speed.
Auto-mode:
Allows for running pre-programmed speeds and times.
3.3 AUTO Polishing Mode
1.
Install working wheel and attach grinding papers / polishing cloths.
Position the specimen holder so that the sample tracks over the entire diameter of the grinding papers in order
to break the grinding papers uniformly. Note positioning is not as significant for polishing pads.
2.
Switch on the head and the base at the back.
Set the button on the head control panel to AUTO.
Set an approximate pressure and head speed on the head.
3.
Set the base speed, time and direction on the base controller (see next page for instructions)
4. Position flexible water spout over working wheel. During sample preparation adjust water flow by turning water
control knob as required. Note: Initial operation of water valve may contain air in the lines. Turn water on
slowly to purge air from system.
5.
Turn on AUTO mode so light is lit. To start operation press START/STOP button to begin.
Auto mode for timed
grinding/polishing
Programming mode
Water switch
Preset speeds
(Low,Meduim,High)
Wheel direction
Speed control
Run/Stop
