Triumph Street Triple R 2022, Owner'S Handbook Manual

Page: 33 / 237

GENERAL INFORMATION
33
Right Handlebar Switches
All Models except Street Triple RS
4
1
5
2
3
1. Engine start/stop switch
2. STOP position
3. RUN position
4. Start position
5. Hazard warning light switch
STOP Position
The STOP position is for emergency use.
If an emergency arises which requires
the engine to be stopped, move the
engine start/stop switch to the STOP
position.
Although the engine stop switch stops
the engine, it does not turn off all the
electrical circuits and may cause
difficulty in restarting the engine due to
a discharged battery. Normally, only the
ignition switch should be used to stop
the engine.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this may cause damage to
electrical
components and will
discharge the battery.
RUN Position
In addition to the ignition switch being
turned to the ON position, the engine
start/stop switch must be in the RUN
position for the motorcycle to operate.
START Position
The START position operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar.
Even if the clutch lever is pulled to the
handlebar, the starter will not operate if
the side stand is down and a gear is
engaged.
Hazard Warning Lights
To turn the hazard warning lights on or
off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched to the PARK
position, until the hazard warning light
switch is pressed again.