２
IMPORTANT NOTES
READ THE INSTALLATION AND OPERATION MANUAL IN ITS ENTIRETY BEFORE
ATTEMPTING TO INSTALL THE LIFT.
•
Do not install this lift on any surface other than concrete, confirming to minimum specifications.
4 inches
at 3,000 PSI
•
Do not install this lift over expansion joints or cracks. Check with building architect.
•
Do not install this lift on a second floor with a
basement.
•
Do not install this lift outdoors
.
•
A level floor is
required
for proper installation and operation. Concrete should be a minimum of 4”
thickness and
3
,000 psi tensile strength.
•
The lift is intended to raise the entire body of the vehicle. Do not attempt to lift only part of the vehicle
.
•
Improper use of this equipment could result in damage to the lift, yourself or other property.
•
The lift is intended to lift vehicles only. It is not designed to lift any person or equipment containing
persons.
•
Users of this equipment should be qualified, responsible and should follow the operation and safety
guidelines set forth in this manual.
•
For specifications on concrete pads
please contact a concrete or foundation specialist.
•
Improper installation can cause damage or injury. The Manufacturer will NOT assume liability for loss or
damage of any kind, expressed or implied, resulting from improper installation to use of this product.
Do not drill holes in the floor until after you have installed
the cables and hoses and used the floor cover to ensure
your posts are at the correct distance ap
ar
t.
Model
Description
Floor Plate
Capacity
Lifting Time
Overall
Height
Overall
Width
Lifting
height
Between
the
upright
columns
NT-
11
Asymmetric
11
000lbs
56 Sec
1
16
'
13
8
”
72”
1
12
”
The installation of this lift is relatively simple and can be accomplished by 2 strong persons in
a few hours. The following tools and equipment are needed:
•
3 gallons of Non-Detergent AW 32 or Standard ATF (Transmission Fluid)
•
Chalk line and 12’ Tape Measure
•
4ft. Level
•
Rotary Hammer Drill with 3/4” Masonry Drill Bit. (Core Drill Rebar Cutter also
recommended)
•
Hammer and Hex Key ‘Allen’ Wrench Set
•
Metric Sockets and Open Wrench set - 13mm-30mm
•
Medium Crescent Wrench and Medium Pipe Wrench
•
Crow Bar for Shim Installation and Medium Flat Screwdriver
•
Vise Grips, Needle Nose and Snap Ring Pliers
Call 866-563-5438 For Help
2
TRIUPMH AUTO LIFTS
TRIUPMH AUTO LIFTS
TRIUPMH AUTO LIFTS
