General Information
Page 19
TEC0006
4
5
1
3
2
1. Odometer Display
2. Trip Meter 1 Display
3. Trip Meter 2 Display
4. Select Button
5. Reset Button
ODOMETER/TRIP METER/CLOCK
The odometer shows the total distance that
the motorcycle has travelled.
There are two trip meters. Either trip meter
shows the distance that the motorcycle has
travelled since the meter on display was last
reset to zero. Also located in the same
display frame is the clock.
To switch between the odometer, trip meter
and clock display modes, press and release
the left hand ‘select’ button. The display will
scroll through in the order;
S
odometer,
S
trip meter 1,
S
trip meter 2,
S
clock.
To reset either of the trip meters to zero,
select and display the trip meter to be zeroed
and press the right hand ‘reset’ button to set
the display to zero.
TEC0007
1
5
4
2
3
1. Clock Display
2. Hours Read-out
3. Minutes Read-out
4. Select Button
5. Reset Button
CLOCK ADJUSTMENT
To reset the clock, select the clock display
and press both ‘select’ and ‘reset’ buttons
together. After a short time, the clock’s hour
display will start to flash.
To reset the hour display, ensure that the
hour display is still flashing then depress the
‘reset’ button to change the setting. Each
individual press will change the setting by
one digit. If the button is held, the display will
continuously scroll through in single digit
increments.
When the correct hour display is shown,
press the ‘select’ button, the minutes display
will begin to flash. The minutes display is
adjusted in the same way as for hours.
Once both hours and minutes are correctly
set, press the ‘select’ button to confirm the
setting. The display will cease to flash.
