Triton T70Z, Installation And Operating Instructions Manual

Page: 13 / 28

T70Z electric shower
13
Fig.9
If installing a feed pipe from the rear or bottom,
the centre of the inlet valve to the wall surface is
21mm
(fig.9) .
Note: If entry is from the rear, the nut of the
compression fitting will be partially behind the
surface of the wall
(fig.9) . This area MUST be
left clear when plastering over the pipework
in order to make the nut accessible for future
adjustments.
IMPORTANT: Always seal around the
incoming pipework to prevent water entering
the wall.
After choosing the site for the shower, use the
fitting template supplied to mark the two fixing
holes.
The location of the fixing holes in the backplate
are shown in
(fig.10) .
Drill and plug the wall. An appropriate drill bit
should be used. If the wall is brick, plasterboard
or a soft building block, appropriate wall plugs
and screws should be fitted.
Screw the top fixing screw into position leaving
the base of the screw head protruding 6mm out
from the wall.
Hook the backplate over the top screw and fit
the bottom fixing screw into position. Do not
fully tighten the screws at this stage, as the fixing
holes are elongated to allow for out of square
adjustment after the plumbing connections have
been completed.
W-004-A
WARNING!
The outlet of the shower acts as a
vent and MUST NOT be connected to
anything other than the hose and
showerhead supplied.
Fig.10
Fixing hole
Fixing hole
21mm