7
T40i
Existing
hose
Hose
supplied
HOSE CONNECTIONS
Fitting to:
-
Bath tap/mixer valve
(fig.2)
-
Mixer valve
(fig.3)
-
Push on with blender valve
(fig.4)
• Remove the existing sprayhead flexible hose
from bath tap/mixer valve/blender mixer
arrangement.
• Screw one end of the supplied flexible hose to
the T40i inlet connection using one of the
sealing washers to seal the joint.
• Screw the other end of the flexible hose to the
mixer outlet using the washer provided to seal
the joint.
• Screw the sprayhead flexible hose to the
outlet of the T40i pump using the washer
provided to seal the joint.
• Remove the sprayhead.
• Hold the end of the hose to waste and turn the
water on to flush the system and to check for
leaks. Turn off the water.
• Replace the sprayhead and turn the water on
again. Leave running to waste until a smooth
(even if poor) flow of water is obtained.
• Turn off the water.
Fitting to:
-
Push-on type connection
(figs.5 & 9)
• Unscrew the sprayhead from the existing hose
then connect the hose to the T40i inlet.
• NOTE:
This is only possible if the hose
terminates with a ½” BSP connection.
Connect the hose supplied to the T40i
outlet using the washer provided to seal
the joint.
• Hold the end of the hose to waste and turn
the water on to flush the system and to check
for leaks.
• Turn off the water.
• Connect the sprayhead to the supplied hose
using the washer provided.
• Turn the water on again and leave running to
waste until a smooth (even if poor) flow of
water is obtained.
• Turn off the water.
Fig.9
IMPORTANT
DO NOT OVERTIGHTEN FITTINGS,
OR KINK OR TWIST HOSES.
