8
t150z pumped thermostatic electric shower
Attached to the display PCB, inside the cover, is a
10-way ribbon cable. The ribbon cable connector
must be plugged into the socket located at the
right of the power PCB situated inside the unit
(fig.0)
.
Note:
The cable connector can be fitted to
the socket only one way. The ribbon cable has
a coloured edge which is at the bottom when
correctly fitted to the socket.
Note:
The ribbon cable is preformed to fold flat
when the cover is fitted.
Important:
Before finally fitting the cover,
the following steps must be taken:
a. Check all plumbing connections are
watertight.
b. Check terminal block screws are fully
tightened.
c. Make sure pipe and cable entering the unit
do not prevent the cover locating correctly
to the backplate.
Offer the cover to the unit.
Guide into position so that the knob spindle
locates correctly (minor adjustment may be
necessary to align the knob and spindle). Should
any difficulty arise, re check the points above.
While applying slight pressure to the cover,
secure in position with the retaining screws.
Turn the electric supply back on at the isolating
switch. The ‘
Power
’ indicator will light. No water
will flow now until the
Start/Stop
button is
pressed.
However, it is recommended that the water and
electric supplies to the shower are turned off
while the riser rail kit is being installed.
The flexible hose can be left attached to the
shower outlet. Make sure the supplied sealing
washer is fitted.
REPLACING THE COVER
Fig.0
