Triton Madrid II, Installation And Operating Instructions Manual, Page: 17 / 28

17
Installation - FITTING THE COVER
Selector
spindle
Fig.13
Fig.14
Fig.15
FITTING THE COVER
• Locate the trimplate into the backplate and
secure with the two fixing screws.
• The power selector spindle must be aligned
as shown (fig.13) .
• To make sure that the temperature control
is correctly positioned on the stabilising
valve, temporarily place the cover in position
so that the splines engage and rotate the
temperature control fully anti-clockwise.
• Remove the cover and position the
temperature control knob so that it points to
the maximum flow position
(fig.14) .
• Position the power selector to the ‘ STOP ‘
position (fig.15) .
• Check to ensure that the wiring is not
trapped and replace the cover squarely to
the backplate and guide into position so that
the knobs locate correctly into the splined
spindles.
• Should any difficulty arise, recheck the
points above.
• While applying slight pressure to the cover,
secure in position with the retaining screws.
• Fit the Riser Rail and Kit (see kit
instructions).
8
check list
SECTION
WARNING
COVER RETAINING SCREWS
ONLY the SUPPLIED SCREWS should be
used. The use of none supplied screws WILL
invalidate product specifications & warranty.