Triton Madrid II, Installation And Operating Instructions Manual, Page: 14 / 28

14
Installation - FIT TO THE WALL & CONNECT THE SHOWER SUPPLIES
Bottom cut out
entry point
Top cut out
entry point
Fig.8
Fig.9
PLEASE NOTE: NONE of the 'cut outs' are designed to 'snap out'. ONLY a junior hacksaw or suitable knife
should be used. Damage to the backplate or lower trimplate may invalidate product specifications and warranty.
ELECTRICAL INSTALLATION
IMPORTANT: Switch off the electricity supply at
the mains before proceeding.
• The supply cable MUST be secured either by
routing through conduit, in trunking, or by
embedding in the wall, in accordance with
IEE regulations.
NOTE: Conduit entry can only be from rear.
Installation - ELECTRICAL INSTALLATION
NOTE: Deviations from the designated entry
points will invalidate product approvals. The
cable entry points are listed on
page 8 .
• Seal around rear entry cable to prevent water
ingress into the wall.
FIT TO THE WALL & CONNECT THE
SHOWER SUPPLIES
• If a bottom entry has been chosen, the ‘cut
out’ pipe entry on the bottom trimplate must
be removed
(fig.8) .
• If a top entry has been chosen, the ‘cut out’
pipe entry on the top of the backplate must
be removed
(fig.9) .
• If a side entry is required, the trimplate side
will have to be cut. With the compression
elbow fitted on the outlet, temporarily place
the trimplate into position, then mark the
pipe entry on the side of the trimplate.
Carefully remove the appropriate area using
a junior hacksaw.
Fitting Procedure
• Turn off water supply either at the mains
stopvalve or the isolating stopvalve.
• Temporarily connect the mains water supply
to the inlet of the shower using a 15mm x
15mm compression fitting.
6
check list
7
check list
SECTION
SECTION