Triton ASPIRANTE XR, Installation And Operating Instructions Manual

Page: 18 / 28

Aspirante xr
18
OPERATING THE SHOWER
MAKE SURE THE COMMISSIONING
PROCEDURE HAS BEEN CARRIED OUT.
When the electricity supply to the shower is
switched on at the isolating switch, the POWER
indicator will light.
To start the shower
Press the START/STOP button and water will
begin to flow.
Note: The default start up setting is the HIGH
setting.
To stop the shower
Press the START/STOP button and the phased
shutdown will begin. Water will cease to flow
after a few seconds.
To use the control buttons
There are two control buttons – HIGH/
ECONOMY and COLD
(fig.20) .
The upper button red symbol is for switching
between the HIGH and ECONOMY power
setting.
The HIGH setting allows the highest flow
achievable for your preferred temperature. This
setting should normally be regarded as optimum
shower performance throughout the year.
The ECONOMY setting uses less energy when
the ambient mains water temperature is high
during hot months.
Note: When starting the shower, the default
setting is HIGH. The red symbol button
alternates between the two settings: press the
button once to select the ECONOMY setting,
press the button again to reselect HIGH.
Temperature adjustment at this setting is via the
temperature control.
The lower button blue symbol is for COLD
water only. Adjusting the temperature control
at this setting will only increase or decrease the
flow of the water from the showerhead; it will
not alter the water temperature.
Operating the shower
OPERATING THE SHOWER
High &
Economy
Cold
Temperature
control
Start/Stop
button
Fig.20
Note: In normal use, it is in order to leave the
water supply permanently on to the shower
unit, but as with most electrical appliances,
the unit must be switched off at the
isolating switch when not in use.