-
８
- XM095 V1.2 NR
Starting address 49 Starting address 25 Starting address 1
Projector DMX starting address selection
All fixtures should be given a DMX starting address when using a DMX signal, so that the correct
fixture responds to the correct control signals. This digital starting address is the channel number
from which the fixture starts to “listen” to the digital control information sent out from the DMX
controller. The allocation of this starting address is achieved by setting the correct number on the
display located on the base of the device.
You can set the same starting address for all fixtures or a group of fixtures, or make different address
for each fixture individually.
If you set the same address, all the units will start to “listen” to the same control signal from the same
channel number. In other words, changing the settings of one channel will affect all the fixtures
simultaneously.
If you set a different address, each unit will start to “listen” to the channel number you have set,
based on the quantity of control channels of the unit. That means changing the settings of one
channel will affect only the selected fixture.
In the case of the moving head, which is 24 channels fixture, you should set the starting address of
the first unit to 1, the second unit to 25(24 + 1), the third unit to 49 (25+ 24), and so on.
Control Board
The Control Board offers several features: you can simply set the starting address, switch on and off the lamp, run
the pre-programmed program or make a reset.
The main menu is accessed by pressing the
Mode/esc
-button until the display starts flashing. Browse through the
menu by pressing the
Up
-button or
Down
-button. Press the
Enter
-button in order to select the desired menu. You
can change the selection by pressing the
Up
-button or
Down
-button. Confirm every selection by pressing the
