21.
User Manual | 7R BEAM PRO Triton Blue | Rev. May.2015 | www.triton-blue.com
english
s
et
dmX
address
Click and select the “ADDR”, can enter the page of DMX address setting, range from 1 to 512, the
address code shouldn´t is not greater than (512 . channels quantity), otherwise the light will not been
controlled. Following is the operation:
Enter the page of DMX address, as shown in Figure 7, click the black area in right side of display will pop-
up dialog as in Figura 4, modify value, then click “Enter” to confirm and save DMX address code.
s
et
light
Work
mode
Enter the page of “ WORK MOD” as shown in Figure 8 and modify setting. Can set light work mode,
control lamp and DMX channel mode.
Light includes 3 work mode: DMX MODE, AUTO RUN and SOUND MODE, Parameter definition as
following:
»
DMX MODE: Under this mode, the light receive data from the DMX controller and move.
»
AUTO RUN: Under this mode, light will run with inside code (data), ignore data from DMX contro-
ller.
»
SOUND CTRL: Under this mode, light ignore data from DMX controller. When there is a strong
sound in stage, the light will run a scene, otherwise it will keep the last scene.
»
M/S CHOOSE: M/S Choose is available when light just in “AUTO RUN” or “SOUND CTRL” mode.
If this item is set as “OFF”, the light don´t send data to other light via DMX cable. When “ON”, the data
will send to other slave light inmediately.
»
LAMP CONTROL: Turn on lamp when this item is set “ON”, otherwise, turn off lamp. The gap
between operation is limited to 30 second.
»
CHANNEL MODE: Light support 2 DMX Channel mode: sample or extend.
