18.
User Manual | 7R BEAM PRO Triton Blue | Rev. May.2015 | www.triton-blue.com
english
Use a cable conforming to specifications EIA RS-485:
• 2-pole twisted.
• Shielded.
• 120Ohm characteristic impedance.
• 22-24 AWG.
• Low capacity.
• Do not use microphone cable or other cable with characteristics differing from those specified. The
end connections must be made using XLR type3 or 5-pin male/female connectors. A terminating plug
must be inserted into the last projector with a resistance of 120Ohm (minimun 1/4W) between terminals
2 and 3.
i
mPortant
:
The wires must not make contact with each other or with the metal casing of the connectors.
The casing itself must be connected to the shield braid and to pin 1 of the connectors.
C
ABLE
CONNECTION
(DMX)
R
IGGING
OPTIONAL
This equipment can be positioned and fixed by clamp in every direction of the stage. Locking system
makes it easy to fasten to the bracket.
Attention! Two clamps is needed to fix the equipment. Every clamp is locked by fastener of 1/4
kind. Fastener can only be locked clockwise.
Attention! Fasten a safety string to the additional hole of side aluminum piece. The secondary
accesory can not hang on the delivery handle.
• Check if rigging clamp (not including the one inside) damaged or not? If stand ten times weight as
the equipment. Make sure the architecture can stand ten times weight as all the equipments, clamps,
wirings and other additional fixtures.
• Screws for clamping must be fixed firmly. Take one M12 screw (Grade 8.8 or higher) to clamp
bracket, and then screw the nuts.
• Level the two hanging points at the bottom of clamp. Insert fastener to the bottom, lock the two
levers by 1/4 rotating clockwise; the install another clamp.
• Install on safety string which stands at least ten times weight as equipment. Terminal of the acces-
sory is designed for clamps.
• Make sure pan/tilt lock unlocked or not. Keep the distance more than 1M from equipment to flam-
mable material or lighting source.
