Use the fin key, to tighten the
screws. Do not tighten too strongly,
as this may cause a damage to the
finbox.
2
Put the fins into the finboxes.
The fins must point backwards and
the TRIPSTIX-Logo must face to the
outside. The centerfin does not have
a logo.
1
Thruster
Position the square nut
underneath the hole in
the fin base and tighten
the screw.
3
Put the single fin into the
finbox. To do so, insert
the pin of the fin into the
fin box and push the fin
backwards.
2
Put the square nut into
the fin box and slide it
to the front part of the
box.
1
Single fin
INSTALLING FINS
Detach the hose and close the
valve cap.
4
Open the valve cap and make
sure that the yellow pin is in
the
UP position
(push and turn).
2
Insert pump hose into the valve and
inflate to pressure written on the
valve ring.
Take extra care when
using a compressor for inflation.
We assume no liability for
the use of a compressor.
3
Unfold the board.
1
HOW TO INFLATE THE BOARD
