7
7. Equipment Installation
(continued)
8. Optional Casters
An optional caster accessory kit
(Model: SRCASTER)
is available separately through Tripp Lite. Go
to www.tripplite.com for details. The SRCASTER Kit consists of 4 casters with required locknuts and
bolts for installation. The casters install to the base of the unit using pre-drilled holes as shown in
the illustration below. For further installation instructions, refer to the manual included with the
SRCASTER Kit.
7.2 Alternate Mounting: Tapped Hole Mounting Rail
WARNING:
Do not attempt to adjust rails while equipment is installed in the enclosure. Do not attempt to use rails without screws
installed. (2 per rail.)
The 2 mounting rails are pre-installed for securing equipment using the square hole side of the mounting rail. To switch to the tapped hole side of the
mounting rail, follow the steps below:
1
Each rail is connected to the enclosure with 2 screws: 1 in the upper corner and another in the
lower corner. Using a Phillips-head screwdriver, remove the screws that fasten the rails to the
enclosure.
2
Switch the rail locations. Ensure the tapped hole side of each rail is facing the front door.
3
Reattach the mounting rails.
4
Use the included silver mounting screws to secure your equipment to the rack rail. Place the
cup washers between the screws and the equipment mounting brackets.
Note:
Your equipment may also include mounting hardware. Read the mounting instructions that came
with your equipment before installing your equipment.
1
3
Upper Rail
Upper Rail
Lower Rail
Lower Rail
2
2
4
