Tripp Lite NGI-M05-C1, Owner'S Manual, Page: 143 / 254

143
configure no loop-detection address This command configures the
destination MAC to default
(00:0b:04:AA:AA:AB).
configure interface IFNAME This command enters the interface
configure node.
interface loop-detection (disable|enable) This command disables / enables the
loop detection on the port.
interface no shutdown This command enables the port. It can
unblock port blocked by loop detection.
interface loop-detection recovery
(disable|enable)
This command enables / disables the
recovery function on the port.
interface loop-detection recovery time
<1-60>
This command configures the recovery
period time.
configure interface range
gigabitethernet1/0/PORTLISTS
This command enters the if-range
configure node.
if-range loop-detection (disable|enable) This command disables / enables the
loop detection on the ports.
if-range loop-detection recovery
(disable|enable)
This command enables / disables the
recovery function on the port.
if-range loop-detection recovery time
<1-60>
This command configures the recovery
period time.
Example:
L2SWITCH(config)#loop-detection enable
L2SWITCH(config)#interface 1/0/1
L2SWITCH(config-if)#loop-detection enable