12
Administrator Setup
IP Installer
The included CD contains a Windows-based
IP Installer
utility that can be used
to obtain and edit the IP address. To use the
IP Installer
utility, the computer you
are using must be running a Windows operating system and must be on the same
network as the IP remote access unit. Also, the
IP Installer
setting in the
Admin Utility
must be set to
Enabled
, which it is by default. (See the
ANMS
section in the Owner’s
Manual for details)
1. Save the
IP Installer
utility file to a desired location on your computer. Double-click
on the file to open the
IP Installer
utility.
2. Select the B051-000 from the
Device List.
Note
: If the list is empty or your device doesn’t appear, click the
Enumerate
button to refresh
the
Device List
. If there is more than one device in the list, use the MAC address on the
bottom of your unit to determine the desired device.
3. To assign a fixed IP address, check the
Specify an IP address
checkbox and
fill in the
IP Address, Subnet Mask
and
Default Gateway
fields with information
appropriate for your network.
4. Click the
Set IP
button to apply the changes to the unit. The new IP address will
appear in the
Device List
.
5. Click the
Exit
button to exit the
IP Installer
utility.
17-11-282 93-373C.indd 12
12/5/2017 4:00:29 PM
