26
9. Appendix A
10. Appendix B
9.3 OSD Factory Default Settings
The factory default settings are as follows:
Setting
Default
OSD Hotkey
[Scroll Lock] [Scroll Lock]
*
Port ID Display Position
Upper Left Corner
Port ID Display Duration
3 Seconds
Port ID Display Mode
The Port Number plus the Port Name
Scan Duration
5 Seconds
Scan/Skip Mode
All
Screen Blanker
0 (Disabled)
Logout Timeout
0 (Disabled)
Accessible Ports
F (Full) for all users on all ports
Beeper
Y (Activated)
* Use of the
[Scroll Lock]
key requires the
[Fn]
key to be held down.
10.1 FCC Notice, Class A
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own
expense. The user must use shielded cables and connectors with this equipment. Any changes
or modifications to this equipment not expressly approved by Tripp Lite could void the user’s
authority to operate this equipment.
14-08-026-933077.indd 26
9/9/2014 11:25:45 AM
