B. Surface Temperature Measurement
1) Set the Thermometer at surface temperature measuring mode by press
.
2) Hold the meter by its handle and point it toward the surface to be
measured.
3) Press the trigger to turn the meter on and take a temperature reading.
"OUT" will be displayed at the left bottom and the adjusted value is
displayed at the bottom right.
4)
Release the Trigger and the reading will hold for approximately 7 seconds
after which the meter will automatically shut off. Trigger presses can occur
up to a rate of one a second to quickly log samples.
C. °C/°F Selection
Hold down the
for few seconds and the Thermometer will switch
between
°
C and
°
F.
D. Temperature Offset
If needed, the Thermometer allow user to adjust the temperature.
1) Press
to select the function.
2) Measure the temperature using the same procedures listed above.
3)
Press or
until the reading in the large display is the same as the
known temperature.
