![Triple S Customs Car Security Installation Manual Download Page 45](http://html1.mh-extra.com/html/triple-s-customs/car-security/car-security_installation-manual_1163902045.webp)
CAR ALARM AND REMOTE START INSTALLATION GUIDE
Copyrght 2002-2004 Triple S Customs
45
TESTING THE PARKING LIGHT WIRE
•
The parking light wire can typically be found behind the headlight switch, at the fuse box, in the driver’s kick
panel, or in a harness from the steering column.
NOTE: Never connect the parking light output to the headlight circuit. Doing so may cause the headlights
to burn out prematurely
To find the parking light wire with your multi-meter:
1. Set to DC voltage
2. Attach the (-) probe to chassis ground
3. Probe the wire you suspect of being the parking light wire
4. Turn on the parking lights. If your meter shows 12V, turn off the parking lights and make sure it goes back to
zero.
5. If it does return to zero, turn the parking lights back on, and turn the dimmer up and down. If the meter
changes more than a volt when using the dimmer, look for another wire. If it stays relatively close to 12V, that
is the correct wire.
WIRING A RELAY FOR PARKING LIGHT FLASH
NOTE:
If the aftermarket unit only has a (-) parking light output, use a relay and wire as shown:
PIN
CONNECTION
85
12V CONSTANT FUSED
86
(-) PARKING LIGHT OUTPUT
87
12V CONSTANT FUSED
87A NOT
CONNECTED
30
TO (+) PARKING LIGHT WIRE