IV.
SERVICE: Removal and installation of the motor.
WARNING!
Disconnect the unit from the electrical power source before attempting any service.
WARNING!
Electrical service should be performed by licensed electricians or authorized Trion
service technicians.
Step 1.
To gain access to the motor, remove the ceiling panel next to the unit, if
applicable.
Step 2.
Remove the four screws and lift the prefilter off the prefilter frame.
Step 3.
Remove the J-Box cover retaining screws and electric box cover and lift both
covers off. (See Figure 3)
Step 4.
Make note of all wire locations for reinstallation later.
Step 5.
Disconnect the two brown wires from the capacitor.
Step 6.
Disconnect the motor wiring from the On/Off switch, ground and neutral and
release the conductor from the J-Box and electrical box.
Figure 3
