3
RJ45 ETHERNET CONNECTOR (TOP)
A standard Ethernet connector is provided for use as the primary programming interface.
The Trio programming software,
Motion
Perfect 4 and above, must be installed on a Windows based PC that
is fitted with an Ethernet connection. The IP address is displayed on the MC4N display for a few seconds after
power-up or when an Ethernet cable is plugged in.
The Standard Ethernet connection may also be used for Ethernet-IP, Modbus and other factory communications.
ETHERCAT PORT
The MC4N acts as an EtherCAT master. EtherCAT drives and I/O devices are normally connected in a chain.
Ethernet standard pin assignment:
Pin
Signal
Description
1
TD+
Transmission data +
2
TD-
Transmission data -
3
RD+
Receive data +
6
RD-
Receive data -
Symetric or cross-over cables can be used between EtherCAT devices. Minimum CAT 5 shielded SF/UTPcable is recommended.
ETHERCAT NETWORK DETECTION
EtherCAT Intelegent drives Window in Motion Perfect
