1.5 THE FRONT PANEL
1
- STANDBY BUTTON
After the left-hand (when viewed from the front of the amplifier) rear-panel POWER switch is
turned on, press the front panel STANDBY button to exit the standby mode. Channels 5-8 will
come out of standby. Channels 1-4 are controlled by the right-hand (when viewed from the
front of the amplifier) rear-panel POWER switch. If both rear-panel POWER switches are turned
on, the STANDBY button will control all channels.
2
- STANDBY LED
Illuminates RED when the amplifier enters the Standby mode.
Illuminates GREEN when the amplifier is in the turn-on sequence.
Illuminates BLUE when the amplifier is ready for normal operation.
3
- PROTECT LED
Illuminates if the unit enters the protection mode. This can be caused by a short circuit in any
of the channels or by an over-temperature operating condition.
1.5 THE REAR PANEL
9
