1.4 SPECIFICATIONS
POWER
POWER REQUIREMENTS
120VAC (90V-132V) / 230VAC (200V-250V) 50/60Hz, 20 Amp fuse
for 120V, 10 Amp fuse for 220V
POWER CONSUMPTION
Less than 0,5W at Standby (for 230V, 1W for 120V); <80W at idle; 40W
at Sleep; 1800W fully loaded
TRIGGER INPUT
5-12 VDC; Steady State
MODES /PROCESS
Standby: Amplifier is ready to be turned on via front panel switch or
remote trigger.
Overcurrent, D.C., and/or thermal protection: Amplifier will cycle.
Catastrophic D.C. or output stage failure: Amplifier will shut down.
AUDIO
GAIN
19 dB
POLARITY
Pin-2 = Positive, Pin-3 = Negative for Non-Inverting Output
INPUT IMPEDANCE
20 k Ohms for each phase
ANALOG AUDIO OUTPUTS
8 pairs of outputs with 5-way binding posts
FREQUENCY RESPONSE
+0, -.5 dB 0 Hz to 20 kHz, load-independent
DAMPING FACTOR
>800 at any frequency up to and including 20 kHz
SIGNAL TO NOISE RATIO
123 dB referenced to rated output (A-Weighted)
CROSSTALK
> 90 dB
POWER OUTPUT
8x8 ohms: 200W RMS per channel with less than 0.05% THD from
20 Hz to 20 kHz
4x4 ohms: 300W RMS per channel with less than 0.05% THD from
20 Hz to 20 kHz
7
