Page 8 of 43
Trilogy Communications
Mentor CX
2.4
M
AINS
C
ONNECTION AND
F
USING
Important
Power Supply Cord(s) Used as Disconnect Means
CAUTION: THE POWER SUPPLY CORDS ARE USED AS THE MAIN DISCONNECT DEVICE.
ENSURE THAT THE SOCKET-OUTLETS ARE LOCATED / INSTALLED NEAR THE EQUIPMENT
AND ARE EASILY ACCESSIBLE.
THIS UNIT HAS MORE THAN ONE POWER SUPPLY CORD.
DISCONNECT TWO POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK.
ATTENTION: LES CORDONS D’ALIMENTATION SONT UTILISÉS COMME DISPOSITIF DE
DÉBRANCHEMENT PRINCIPAL. ASSUREZ-VOUS QUE LES PRISES DE SOCKET SONT SITUÉES /
INSTALLÉES PRÈS DE L’APPAREIL ET SONT FACILEMENT ACCESSIBLES.
CET APPAREIL COMPORTE PLUS D’UN CORDON D’ALIMENTATION.
AFIN DE PRÉVENIR LES CHOCS ÉLECTRIQUES, DEBRANCHER LES DEUX CORDONS D’ALIMENTATION
AVANT DE FAIRE LE DÉPANNAGE.
The power supplies within the unit are a switched mode design and will cope automatically with a
wide input voltage range (see specification, section 9.3).
The standard Mentor CX is fitted with a single mains power supply unit (PSU), with an option to fit a
second PSU. Each PSU has its own, dedicated, IEC mains plug on the rear of the Mentor CX. These
should be wired according to the instructions provided with a mating mains socket using suitable
cable. See above for earthing requirements.
Mains cable conductors are to be three-core (two-wire with ground), wire gauge 18 AWG (cross
sectional area 0.75mm²) Jacket to be type SJT.
Covers are only to be removed by trained personnel. Shock hazard exists with covers removed;
therefore disconnect mains supply before removal. See the warning notice above. Interconnection
between circuit boards and panels are all safety extra low voltage (SELV) as defined by
IEC/EN/CSA/UL 60950-1-200X. The equipment signal connections must only be connected to SELV
circuits to prevent hazards from improper connection.
2.5
B
ATTERY
Mentor CX is fitted with an internal lithium battery.
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
ATTENTION
IL Y A RISQUE D’EXPLOSION SI LA BATTERIE EST REMPLACÉE PAR UNE BATTERIE
DE TYPE INCORRECT.
METTRE AU REBUT LES BATTERIES USAGÉES CONFORMÉMENT AUX INSTRUCTIONS.
