SecureMesh
TM
Gateway
Installation Guide
Trilliant Incorporated
page 11 of 23
Utility Pole Installation
To install a Gateway on a utility pole, observe the following procedures:
Mounting the Device
Mount the Bracket
•
The DK-0029A vertical pole mounting bracket has an
extension arm and a mounting pole as shown on the
right.
•
Mount the equipment extension arm to the utility pole
using bolts or bands.
•
Attach a steel mounting pole through the end of the
extension arm using the 5/8” attached bolt on the bottom
of the pole mount. Firmly tighten.
Attach The Gateway to the Bracket
Use the provided mounting bracket and appropriate length
¼“diameter screws that are provided in the accessory kit to
attach the SecureMesh Gateway to the mounting pole (see
the figure on the right).
Note that screws 1" in length can accommodate a pole
diameter up to 1½" while screws 2" in length accommodate a
pole diameter of 2
-
1/8”.
The screws should be tightened to 20 foot-pounds (27
Newton-meters) of torque.
equipment
extension arm
utility pole
mounting pole
