Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings Inc., its subsidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
24
Installation Guide for SecureMesh WAN® Gateway 2 - PL-0073A
Figure 9:
Align the ribs in the coupling nut
5. Feed the Cat6 cable through the strain relief, round rubber seal, and connector
body in the order shown in
Figure 10:
Proper order of connector body, rubber seal, and strain relief
6. Trim the Cat6 cable to the appropriate length so that it can connect between
the GATE-2000 and the surge suppressor, while forming a drip loop and
adequate service loop.
7. Terminate both ends of the Cat6 cable with a Shielded RJ45 connector.
Note:
Ensure the RJ45 shield frame is connected to the
Cat6's foil shield or drain wire.
