![background image](http://html.mh-extra.com/html/trikke/colt/colt_owners-manual_1162648010.webp)
Trikke Colt Owner’s Manual - V0 11/18/14 -
page 9
STEP 3
Adjusting Handlebar Height
Unlock the quick release lever to raise or lower the level
of the handlebar. Notice the round holes down the back
of the handle bar stem post, which provide a number of
height-locking positions. A spring loaded locking pin
snaps into these holes to provide a second level of safety
while riding. Push the locking pin IN to release the stem
post and telescope the handlebars to your preferred
riding height. Once the height has been set, make sure
to close the quick-release clamp.
The quick-release clamp must
feel tight when closing the
lever. If needed, the
tension can be adjusted
through the finger nut.
STEP 4
Attaching and Aligning
the Front Fork
Mounting the front fork assembly to the
steering axle requires a 5mm Hex wrench
(supplied). First, turn the vehicle upside down
so the fork post (arrow right) is aiming towards
the sky. You should do this procedure on a
carpet or soft surface to prevent scratching the
handlebars or damaging the throttle.
OPEN/
CLOSE
PUSH
Adjust
clamping
tension by
tightening
the nut.
4.1
- Inspecting the steering axle
you will find a spring loaded
locking pin. On the fork, you will
also find a slot to secure the
locking pin on the front face of it.
The
handlebar
resting on
the ground
provides a
good
support
for the
assembly.