Trikdis G16T 3 Series, User Manual

Page: 17 / 25

www.trikdis.com 17 July, 2018
GSM communicator G16T_3xxx
Name Description
FW Firmware version
HW Hardware version
State HID – connected via USB; State: Remote – connected via GPRS/3G
Admin or Installer Access level (shows up after access code is confirmed)
Set operation parameters
System settings window
General

Write an appropriate Object ID (4 symbols hexadecimal number).

Use security panel account ID - Account ID is set in control panel, if enabled it will be transmitted to a G16T_3xxx.

Wait acknowledgement from ARC - after a successful reception of a message, the ARC sends a kissoff signal to
communicator. If the communicator does not receive the kissoff tone in time, it retransmits the message.

Line supervision-Supervision of communicator and control panel connection. Reacts when communication with control
panel is lost. To enable this feature, connect communicator`s contact T-1/IN1, R-1/IN2 with control panel`s contact R-1
and T-1. (refer to 5.4 Wiring diagram).

Test period: periodic test messages will be sent according to a time interval set in this section.

Input IN1-IN2 type - choose an input operation type from list IN1-IN2.

Output OUT1 mode - choose an output operation type from list OUT1.

Time synchronization - specify time synchronization (Communicator will use time according to selected server) and
output/input parameters.
Access
The communicator G16T_3xxx have two access levels for configuring the communicator:

Administrator code - allows full access to the configuration.

Installer code - allows limited access for installer to the configuration.
Note: Administrator and Installer codes must be six symbols in length, and contain digits or Latin characters only.